Esther williams swimming pool installation manual

#Esther williams swimming pool installation manual free#

The system should now be free of air and recirculating water to and from the pool.Д§. When water comes out of the filter air relief valve, close the valve. Open the air relief valve on the filter, and stand clear of the filter.Д¦. Reassemble the l system id and locking ring into the strainer pot. Fill the system strainer pot with water.ДЈ.

Remove the system lid and locking ring.Дў. Follow the steps below to prime the pump:ДЎ. The system strainer pot must be filled with water before the pump is initially started. NOTE: Running the system dry could cause a loss of pressure, resulting in damage to the pump case, impeller and seal. Be sure to reopen valves prior to operating. If the system is installed below the water level of the pool, close return and suction lines prior to opening hair and lint pot on pump. Stand clear of the filter or other pressurized vessels. Pool return is completely open and clear of any blockages. Before turning the pump ON, be sure the following conditions are met: 1. Continued operation in this manner could cause a loss of pressure, resulting in damage to the pump case, impeller and seal and may cause property damage and personal injury. ALWAYS maintain proper water level in your pool,(half way up skimmer opening).If the water level falls below the skimmer opening, the pump will draw air through the skimmer, losing the prime and causing the pump to run dry, resulting in a damaged seal. If this occurs, the damaged seal must be replaced. If the system is run dry, the mechanical seal will be damaged and the pump will start leaking. Shutting-off the Fountain2.1 Switch of individual magnetic switch and breakers to shut-off the pump.ДO NOT run the system dry. Starting the Fountain1.1 Check cleanliness and ideal water level of the pond.1.2 Be sure that all underwater lightings are submerging in water.1.3 Check the condition of suction screen filter of any particles that may block the water flow.1.4 Check all the ball valve for their proper setting.1.5 Switch on the circuit breaker for their power supply and push on the magnetic switch to start up the pump.1.6 Do not start the entire pump simultaneously, allow at least 10 seconds interval for the next pump to start.2. OPERATING THE SYSTEMSDaily Operation Procedure1.

TABLE OF CONTENTSImportant System Warning and Safety Instruction.iiSystem Overview.1-3Operating the System.4-5Maintenance/Servicing.6-9List of Equipments and Components.10

Esther williams swimming pool installation manual